You can often find it in the section 9 of safety data sheets.. Regulatory Implications of Auto-ignition Temperature The test follows EN ISO/IEC 80079-20-2:2016 (Explosive atmospheres Part 20-2: Material characteristics - Combustible dusts test methods). Minimum Auto-ignition Temperature of Hydrocarbons  Experiments have found, for example, that the auto-ignition temperature for newspaper is about four degrees lower than that of the filter paper used in chemistry laboratories. The figure below shows the auto-ignition temperatures of hydrocarbons at atmospheric pressure. ★ ★ HOPE THIS HELPS U BUDDY (^_^) !! A material with a low auto-ignition temperature is a greater fire hazard than a material with a high auto-ignition temperature. Little Pro on 2016-01-13 Views: Update:2019-11-16. Auto-ignition temperature is the lowest temperature at which a chemical will spontaneously ignite in a normal atmosphere without an external source of ignition, such as a flame or spark. » IGNITION TEMPERATURE : It means that a substance is the lowest temperature at which it spontaneously ignites in normal atmosphere without an external source of ignition. Fuels and their flash points for some common substances at atmospheric pressure are indicated below: Fuel Type: Temp (Deg C) Temp (Deg F) Acetaldehyde -37.78-36: Acetone -17-78: 0: Benzene -11.11 Table 1: Typical minimum ignition temperatures of various dusts. minimum auto-ignition temperature is the lowest temperature at which the fuel vapours spontaneously ignite. Ignition temperature definition is - the lowest temperature at which a combustible substance when heated (as in a bath of molten metal) takes fire in air and continues to burn —called also autogenous ignition temperature. The auto-ignition temperature or kindling point of a substance is the lowest temperature at which it will spontaneously ignite in a normal atmosphere without an external source of ignition, such as a flame or spark. Hydrocarbons that have been heated can ignite if they are exposed to air. Autoignition Temperatures and Flash Points for Hydrocarbons - Autoignition temperature and flash point ( °C and °F) of different types of hydrocarbons with varying carbon number up to C12 ; Biogas - Carbon Nitrogen Ratios - Carbon - Nitrogen ratios for biogas produced from various raw materials When material is stored in silos, bins and fuel deposits, the minimal ignition temperature drops rapidly. » BEST EXAMPLE : Candle flame & Fire. Minimum ignition temperature (MIT) Minimum ignition temperature of a dust cloud The minimum ignition temperature (MIT) is the lowest temperature of a hot surface that will cause a dust cloud, rather than a dust layer, to ignite and propagate flame. Ignition Temperatures of Materials Auto-ignition temperature - the minimum temperature required to ignite a dry material in air without a spark or flame being present: Fuel or Chemical While autoignition temperature is measured in a laboratory, the actual temperature of ignition in a vehicle is significantly affected by many factors. Autoignition / Hot Surface Ignition. The Auto-Ignition Temperature (AIT) is the minimum temperature at which a chemical (e. g., vapor) will spontaneously ignite without an external ignition source such as a spark or pilot flame – under specific conditions – in an oxidant, which is usually air. This temperature is required to supply the activation energy needed for combustion. Auto-ignition Temperature. Hot surface ignition is governed by the temperature of surfaces in the vehicle, the autoignition properties of the flammable materials, and factors that influence these parameters. For example, the minimum ignition temperature of dust clouds and layer deposites are given in the following table.